Home > Water Heater > Electric Hot Water Heater Not Working Troubleshooting

Electric Hot Water Heater Not Working Troubleshooting

Contents

THEN CLICK HERE WATER HEATER BASICS CHOOSING A WATER HEATER THE TANK: A FORUM TROUBLESHOOTING ROTTEN-EGG ODOR THE FUTURE OF WATER HEATING COMMERCIAL WATER HEATERS WHAT PEOPLE SAY ABOUT US SITE Russell, Before replacing a water heater element I'd check to confirm that it is defective. A: I apologize for not responding sooner. Make sure the tester is working by putting the tip into an outlet you know has power. http://intrascol.org/water-heater/electric-rv-water-heater-not-working.html

With both thermostat dials set to minimum, I checked the upper thermostat (3 terminal) two left terminals and measured infinite resistance. The top thermostat has 2 positions - it can switch voltage to "one position or the other": (position 1) to the top element or (position 2) to the lower thermostat. Replace the TPR valve again. Add to Want to watch this again later? http://www.whirlpoolwaterheaters.com/owner-center/installation-video-guides/electric-installation-videos-guides/troubleshooting-repair/

Electric Water Heater Reset Button

Smith Water Heaters, Technical Training Department, Ashland, TN, Tel: 1-800-527-1953, Website: www.aosmithwaterheaters.com, Publication #320991-000, July 2006. If you are unfamiliar with multimeters and 240 volts, DON'T ATTEMPT THIS. Test both hot wires. Frequently Asked Questions (FAQs) Click to Show or Hide FAQs Please see the electric water heater repair questions & answers now found at ELECTRIC WATER HEATER REPAIR FAQs ...

Current (amps) is the result of circuit voltage and resistance. GE is actually Rheem. Most professional electricians have "clamp on" type ammeters which allows the troubleshooting process to progress very quickly and easily. Gas Water Heater Not Working Do let us know what you find. -- Larry A2: Larry, If WH was wired using 2 wire (with ground) nonmetalic sheathed cable, there very well could be a white wire.

You may need to drain water pressure from the system or even drain piping in order to make repairs, especially if soldering is needed. Then hold the tester against the metal water heater shell. Remember, higher temperatures (above 120ºF) can cause serious injuries. http://www.water-heater-repair-guide.com/electricwaterheatertroubleshooting.html Any idea where I can find a better thermostat that will fit?

All connections in the fuse-box need to be looked at as there is likely a loose one that's shorting. Electric Hot Water Heater Not Working After Power Outage Any good electrician will know what to do. Green links show where you are. © Copyright 2015 InspectApedia.com, All Rights Reserved. If you find you have 240 at element screws but it's not heating, then the element must be bad, but you should already have tested for that.

  • If a timer is installed for your heater, it might be in its "off" position.
  • Carson Dunlop Associates' home inspection education products include The ASHI-adopted Home Inspection Training Program, and Commercial Building Inspection Courses The Home Inspection Home Study Course, and publications such as The Home
  • Simple U-shape elements are the cheapest.

My Water Heater Is Not Heating Water

Three of the four terminals are numbered and visible in the picture (#1, #3, & #4; the #2 terminal is not identified as it is connected directly to the thermostat below http://www.familyhandyman.com/plumbing/water-heater/diy-hot-water-heater-repair/view-all Photo Credit: Julia Nichols / Getty Images Updated October 26, 2016. Electric Water Heater Reset Button Test upper heating element and replace if required.If power is being provided to electric heating element thermostat, replace thermostat or heating element. 2 of 9 Show All 1 Electric Water Heater How To Tell If Electric Water Heater Is Working HIRE A PLUMBER OR ELECTRICIAN.

If you don't have hot water after two hours (water not even warm), first check to make sure the water heater is getting electrical power. http://intrascol.org/water-heater/electric-water-heater-not-working.html Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... Occasionally, leaks can be found coming from a fitting (such as around the Temperature and Pressure Relief Valve) or around one of the heating elements. This OL or 1 indication represents a value greater than the meter is capable of displaying (similar to the way a calculator does) for "overload" or "infinity". Electric Water Heater Thermostat

However, I didn't hear any knocking this time. If it won’t unscrew, use a cold chisel and hammer to loosen the threads.

Photo 5: Install the new element Thread the new element into the water heater and tighten Cleaning Hot Water Heater - Clean your water heater without chemicals. navigate here I figure I'll change both elements and maybe the two thermostats to boot and whatever caused the fuse box to overheat should go away.

If problem still remains, replace water heater with a plastic lined tank type. 7 of 9 Show All 1 Electric Water Heater Troubleshooting 2 PROBLEM: No Hot Water 3 PROBLEM: Inadequate How To Test Water Heater Element If so, that's what caused the problem. Press the black probe firmly against the metal tank or the heating element mounting nuts or screws (not the other terminal screw).

Read the meter display.

Some new tanks do come with only one element at the bottom, which simplifies the heater but also makes it more likely to leave you cold. -- Larry (9/27/04) Keeps Blowing Did you notice that the water was hotter before it went cold? ehowathomechannel 175,584 views 2:04 Change a hot water heater element without draining or spilling water - Duration: 3:25. Not Enough Hot Water From Electric Water Heater Flag as...

If there is water flow, then their is a crossed connection somewhere. Reader's Digest Taste of Home Recipes © 2016 HOME SERVICE PUBLICATIONS, INC. Check elements. 4. his comment is here Then install the new element, using the wrench to tighten it, and reconnect the wires (Photo 5).

Add a photo Upload error Article Info Featured Article Categories: Featured Articles | Water Heating Systems In other languages: Português:Reparar um Aquecedor de Água Elétrico,Русский:отремонтировать водонагреватель,Italiano:Riparare uno Scaldabagno Elettrico,Español:reparar un calentador The dial may indicate letters "A" "B" "C" etc., "warm, hot and hotter" or as in the case of the one pictured, the actual temperature in degrees. The curcuit wasnt tripped, and I couldnt figure the problem. I turned the breaker back on, and 3-4 minutes later it tripped again.

Try unscrewing the bad element by turning it counterclockwise (Photo 4). We're going to take you on a tour as you follow the electricity down from the breaker box, eliminating suspects as we go.